Linux version 2.2.10 (root@black) (gcc version egcs-2.91.66 Debian GNU/Linux (egcs-1.1.2 release)) #1 Sat Jun 26 17:41:28 EDT 1999
Detected 330879182 Hz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 330.14 BogoMIPS
Memory: 95872k/98304k available (744k kernel code, 412k reserved, 1224k data, 52k init)
CPU: Intel Celeron (Mendocino) stepping 0a
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35 (19990512) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xfc04e
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
Starting kswapd v 1.5 
vesafb: framebuffer at 0xf6000000, mapped to 0xc6800000, size 4032k
vesafb: mode is 1024x768x16, linelength=2048, pages=1
vesafb: protected mode interface info at c000:ab00
vesafb: scrolling: redraw
vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0
Console: switching to colour frame buffer device 128x48
fb0: VESA VGA frame buffer device
Detected PS/2 Mouse Port.
pty: 256 Unix98 ptys configured
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.9)
Sound initialization started
Sound initialization complete
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0x0860-0x0867, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0x0868-0x086f, BIOS settings: hdc:pio, hdd:pio
hda: IBM-DBCA-206480, ATA DISK drive
hdc: TOSHIBA CD-ROM XM-1902B, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: IBM-DBCA-206480, 6194MB w/420kB Cache, CHS=789/255/63
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
Partition check:
 hda: hda1 hda2 < hda5 hda6 hda7 > hda3 hda4
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 52k freed
Adding Swap: 128484k swap-space (priority -1)
Linux PCMCIA Card Services 3.0.12
  kernel build: 2.2.10 unknown
  options:  [pci] [cardbus] [apm]
Intel PCIC probe: 
  TI 1225 PCI-to-CardBus at bus 0 slot 3, mem 0x68000000, 2 sockets
    host opts [0]: [ring] [serial pci & irq] [no pci irq] [lat 32/176] [bus 32/34]
    host opts [1]: [ring] [serial pci & irq] [no pci irq] [lat 32/176] [bus 35/37]
    ISA irqs (scanned) = 3,4,5,7,9,10 status change on irq 10
cs: IO port probe 0x1000-0x17ff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x290-0x297 0x378-0x37f 0x3e8-0x3ff 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
3c59x.c:v0.99L 5/28/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
cs: cb_config(bus 35): vendor 0x10b7, device 0x5157
  fn 0 bar 1: io 0x200-0x27f
  fn 0 bar 2: mem 0x60021000-0x6002107f
  fn 0 bar 3: mem 0x60020000-0x6002007f
  fn 0 rom: mem 0x60000000-0x6001ffff
cs: cb_enable(bus 35)
  bridge io map 0 (flags 0x21): 0x200-0x27f
  bridge mem map 0 (flags 0x1): 0x60000000-0x60021fff
vortex_attach(bus 35, function 0, device 5157)
eth0: 3Com 3CCFE575 Cyclone CardBus at 0x200,  00:50:04:29:4f:d7, IRQ 3
eth0: CardBus functions mapped 60020000->c6c26000 (PCMCIA committee brain-damage).
  8K byte-wide RAM 5:3 Rx:Tx split, MII interface.
  MII transceiver found at address 0, status 7809.
  Enabling bus-master transmits and whole-frame receives.